Removal of arsenic(III,V) by a granular Mn-oxide-doped Al oxide adsorbent: surface characterization and performance

In order to remove arsenic (As) from contaminated water, granular Mn-oxide-doped Al oxide (GMAO) was fabricated using the compression method with the addition of organic binder. The analysis results of XRD, SEM, and BET indicated that GMAO was microporous with a large specific surface area of 54.26 m^2/g, and it was formed through the aggregation of massive Al/Mn oxide nanoparticles with an amorphous pattern. EDX, mapping, FTIR, and XPS results showed the uniform distribution of Al/Mn elements and numerous hydroxyl groups on the adsorbent surface. Compression tests indicated a satisfactory mechanical strength of GMAO. Batch adsorption results showed that As(V) adsorption achieved equilibrium faster than As(III), whereas the maximum adsorption capacity of As(III) estimated from the Langmuir isotherm at 25 °C (48.52 mg/g) was greater than that of As(V) (37.94 mg/g). The As removal efficiency could be maintained in a wide pH range of 3~8. The presence of phosphate posed a significant adverse effect on As adsorption due to the competition mechanisms. In contrast, Ca²⁺ and Mg²⁺ could favor As adsorption via cation-bridge involvement. A regeneration method was developed by using sodium hydroxide solution for As elution from saturated adsorbents, which permitted GMAO to keep over 75% of its As adsorption capacity even after five adsorption–regeneration cycles. Column experiments showed that the breakthrough volumes for the treatment of As(III)-spiked and As(V)-spiked water (As concentration = 100 μg/L) were 2224 and 1952, respectively. Overall, GMAO is a potential adsorbent for effectively removing As from As-contaminated groundwater in filter application.

     

Research status,challenges and future prospects of renewable synthetic fuel catalysts for CO2 photocatalytic reduction conversion

Environmental Science and Pollution Research - In recent years, with global climate change, the utilization of carbon dioxide as a resource has become an important goal of human society to achieve...     

Pyrolysis technologies for municipal solid waste: A review

Pyrolysis has been examined as an attractive alternative to incineration for municipal solid waste (MSW) disposal that allows energy and resource recovery; however, it has seldom been applied independently with the output of pyrolysis products as end products. This review addresses the state-of-the-art of MSW pyrolysis in regards to its technologies and reactors, products and environmental impacts. In this review, first, the influence of important operating parameters such as final temperature, heating rate (HR) and residence time in the reaction zone on the pyrolysis behaviours and products is reviewed; then the pyrolysis technologies and reactors adopted in literatures and scale-up plants are evaluated. Third, the yields and main properties of the pyrolytic products from individual MSW components, refuse-derived fuel (RDF) made from MSW, and MSW are summarised. In the fourth section, in addition to emissions from pyrolysis processes, such as HCl, SO₂ and NH₃, contaminants in the products, including PCDD/F and heavy metals, are also reviewed, and available measures for improving the environmental impacts of pyrolysis are surveyed. It can be concluded that the single pyrolysis process is an effective waste-to-energy convertor but is not a guaranteed clean solution for MSW disposal. Based on this information, the prospects of applying pyrolysis technologies to dealing with MSW are evaluated and suggested.     

Effect of Soybean Cultivation on Soil Collembola Community in Marshland of Sanjiang Plain,China

The Sanjiang Plain, the largest inland freshwater marshland in China, was extensive reclaimed into agricultural land. To assess the effects of marshland reclamation on Collembola, we investigated collembolan communities in a chronosequence of soybean plantations (2, 15, and 25 years) in Sanjiang marshland, Northeastern China. We found that: 1) the densities and species richness of Collembola were promoted after short-term (2 years) cultivation of soybean, but significantly decreased after medium-term cultivation (15 years); 2) the densities of epi-edaphic Collembola increased while the densities of hemi-edaphic Collembola decreased as the elongation of soybean cultivation; 3) compared with S0, two species of Collembola appeared while five species disappeared in S25. The changes of plant communities and the soil traits were supposed to be the key factors affecting the composition of soil Collembola. We thus suggest that original marshland should be saved for preserving high diversity and densities of Collembola in the Sanjiang Plain.

     

Vegetation dynamics and climate change on the Loess Plateau,China: 1982–2011

Monitoring the dynamics of vegetation growth and its response to climate change is important to understand the mechanisms underlying ecosystem behaviors. This study investigated the relationship between vegetation growth and climate change during the growing seasons on the Loess Plateau in China by analyzing the normalized difference vegetation index (NDVI) derived from the Land Long Term Data Record dataset from 1982 to 2011. Results showed that growing-season NDVI had increased at an annual rate of 0.0028, particularly in the semi-arid and semi-humid regions. By contrast, the NDVI first increased from 1982 to 1994 (0.0013 year^?1, P < 0.05) and then decreased from 1994 to 2011 (0.0016 year^?1, P < 0.05) in the arid region. Temperature had a positive effect on NDVI in most periods within and across seasons in the semi-humid region but had no significant effect in the arid region. Precipitation had a positive effect on NDVI in the arid region in summer and in the semi-arid region in autumn. Summer precipitation was important for autumn vegetation growth in the arid region, whereas summer temperature increased autumn vegetation growth in the semi-arid and semi-humid regions. Further analyses supported the lag-time effects of climate change on vegetation growth on the Loess Plateau. Precipitation shifts had 15- to 18-month time lag effects on vegetation growth in the three climate regions. Vegetation NDVI had a 17-month lag response to temperature in the semi-arid region. Human activities should not be neglected in analyzing the relationship between vegetation growth and climate change on the Loess Plateau.     

Co-pyrolysis of swine manure with agricultural plastic waste: Laboratory-scale study

Manure-derived biochar is the solid product resulting from pyrolysis of animal manures. It has considerable potential both to improve soil quality with high levels of nutrients and to reduce contaminants in water and soil. However, the combustible gas produced from manure pyrolysis generally does not provide enough energy to sustain the pyrolysis process. Supplementing this process may be achieved with spent agricultural plastic films; these feedstocks have large amounts of available energy. Plastic films are often used in soil fumigation. They are usually disposed in landfills, which is wasteful, expensive, and environmentally unsustainable. The objective of this work was to investigate both the energetics of co-pyrolyzing swine solids with spent plastic mulch films (SPM) and the characteristics of its gas, liquid, and solid byproducts. The heating value of the product gas from co-pyrolysis was found to be much higher than that of natural gas; furthermore, the gas had no detectable toxic fumigants. Energetically, sustaining pyrolysis of the swine solids through the energy of the product gas could be achieved by co-pyrolyzing dewatered swine solids (25% m/m) with just 10% SPM. If more than 10% SPM is used, the co-pyrolysis would generate surplus energy which could be used for power generation. Biochars produced from co-pyrolyzing SPM and swine solid were similar to swine solid alone based on the surface area and the ¹H NMR spectra. The results of this study demonstrated the potential of using pyrolysis technology to manage two prominent agricultural waste streams (SPM and swine solids) while producing value-added biochar and a power source that could be used for local farm operations.     

石英砂滤料表面润湿改性

采用硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂对石英砂进行表面改性,以制备亲油疏水性滤料。研究得出,钛酸酯偶联剂改性石英砂的最佳工艺条件为:偶联剂用量15%,反应温度90℃,搅拌时间15 min;硅烷偶联剂和铝酸酯偶联剂改性石英砂的最佳工艺条件均为:偶联剂用量15%,反应温度110℃,搅拌时间15 min。水对钛酸酯偶联剂改性石英砂滤料的润湿重量由改性前的1.5589 g降低到0.0282 g,水对硅烷偶联剂改性石英砂滤料的润湿重量降低到0.0607 g,水对铝酸酯改性石英砂滤料的润湿重量降低到0.2664 g。静态吸附实验表明,硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂改性石英砂滤料对油的吸附容量分别增加了33.67%、42.87%和22.30%。XPS和FT-IR分析表明,偶联剂均以化学键的方式包覆在石英砂滤料表面,结合稳定。     

大型蚤标志酶用于城市二级出水毒性的评价

大型蚤是一种国际公认的标准实验生物,广泛应用于污水、地表水等水质毒性检测。毒性水平较低的城市二级出水,对大型蚤往往无急性毒性效应,而具有慢性毒性效应,但慢性毒性检测周期过长,因此探索一种更灵敏的指标,实现快速检测,对于控制二级出水的水质风险具有重要意义。本研究考察了大型蚤在短期暴露于城市二级出水条件下,其体内乙酰胆碱酯酶、超氧化物歧化酶、过氧化氢酶、ATP酶、羧酸酯酶和碱性磷酸酯酶的酶活变化特征,从中筛选出对二级出水毒性响应灵敏的标志酶指标。实验结果表明,碱性磷酸酯酶、过氧化氢酶对二级出水毒性响应相对较灵敏,具有成为标志酶的潜力,研究结果为城市二级出水生物毒性评价方法优化提供新的思路。     

内窥镜检查在电站锅炉内部检验中的应用

工业内窥镜是电站锅炉内部检验中不可或缺的设备,主要用来对集箱、减温器、受热面管等内部人眼无法观察到的地方进行检验,从而确定承压部件内部是否存在严重影响锅炉安全运行的缺陷.本文通过对锅炉内窥实例进行分析和总结,阐述内窥镜检查在锅炉内检中的重要性并给相关工作人员提供借鉴与参考.     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.